INSPECTION LIST
INSPECTION DIMENSION	TARGET VALUE	TOLERANCE	MEASURED VALUE
			INSPECTED PIECES
			1ST	2ND	5TH	10TH	20TH	50TH	100TH	150TH	200TH
CORE Ø AT FRONT OF L.O.C.	`='[Θ]Sheet1'!$I$11	`=CONCATENATE("+",FIXED('[Θ]Sheet1'!$A$46,4)," -0.0000")
PRIMARY LAND WIDTH TIP	`='[Θ]Sheet1'!$I$8	`=CONCATENATE("±",FIXED('[Θ]Sheet1'!$A$48,4))
RADIAL RELIEF WIDTH	`='[Θ]Sheet1'!$I$9	`=CONCATENATE("±",FIXED('[Θ]Sheet1'!$A$49,4))
RADIAL DROP	`='[Θ]Sheet1'!$I$10	`=CONCATENATE("±",FIXED('[Θ]Sheet1'!$A$50,4))
TIP DISH	`=CONCATENATE(FIXED('[Θ]Sheet1'!$A$17,1),"º")	0º = TRUE  /  >0º = ±0.25º
WEB THICKNESS	`='[Θ]Sheet1'!$B$18	`=CONCATENATE("+",FIXED('[Θ]Sheet1'!$A$51,4)," -0.0000")
GASH LENGTH PAST CENTER	=B10	`=CONCATENATE("±",FIXED('[Θ]Sheet1'!$A$52,4))
NOTCH GRIND START POSITION	`='[Θ]Sheet1'!$I$25	`=CONCATENATE("+",FIXED('[Θ]Sheet1'!$A$55,4)," -0.0000")
NOTCH GRIND WALK LENGTH	`='[Θ]Sheet1'!$I$27	`=CONCATENATE("+",FIXED('[Θ]Sheet1'!$A$56,4)," -0.0000")
GASH 1 WALK LENGTH	`='[Θ]Sheet1'!$I$23	`=CONCATENATE("±",FIXED('[Θ]Sheet1'!$A$53,4))
GASH 2 WALK LENGTH	`='[Θ]Sheet1'!$I$24	`=CONCATENATE("±",FIXED('[Θ]Sheet1'!$A$54,4))
GASH 3 WALK LENGTH	=B15	=C15
BLANK Ø	`='[Θ]Sheet1'!$A$36	`=CONCATENATE("+ 0.0000 -",FIXED('[Θ]Sheet1'!$A$43,4))
CUTTING Ø AT FRONT OF L.O.C.	`='[Θ]Sheet1'!$H$35	`=CONCATENATE("+ 0.0000 -",FIXED('[Θ]Sheet1'!$A$44,4))
CHIP BREAKER DEPTH	`='[Θ]Sheet1'!$B$29	+0.0010 -0.0000
CHIP BREAKER START POSITION	`='[Θ]Sheet1'!$A$40	±0.0050
L.O.C.	`='[Θ]Sheet1'!$H$37	`=CONCATENATE("±",FIXED('[Θ]Sheet1'!$A$45,4))
			INITIALS
VERIFY CORE TAPER IS WITHIN SPEC PER SHOP DRAWING
VERIFY CUTTING Ø TAPER IS WITHIN SPEC PER SHOP DRAWING